* One Top Fuel dragster 500 cubic-inch Hemi engine makes more horsepower than the first 4 rows at the Daytona 500.
*
Under full throttle, a dragster engine consumes 11.2 gallons of nitro
methane per second; a fully loaded 747 consumes jet fuel at the same
rate with 25% less energy being produced.
* A stock Dodge Hemi V8 engine cannot produce enough power to merely drive the dragster’s supercharger.
* Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.
*
Spark plug electrodes are totally consumed during a pass. After 1/2
way, the engine is dieseling from compression plus the glow of exhaust
valves at 1400 degrees F. The engine can only be shut down by cutting
the fuel flow.
* If spark momentarily fails early in the run,
unburned nitro builds up in the affected cylinders and then explodes
with sufficient force to blow cylinder heads off the block in pieces or
split the block in half.
* Dragsters reach over 300 MPH before you have completed reading this sentence.
*
In order to exceed 300 MPH in 4.5 seconds, dragsters must accelerate an
average of over 4 G’s. In order to reach 200 MPH well before
half-track, the launch acceleration approaches 8 G’s.
* Top Fuel engines turn approximately 540 revolutions from light to light!
* Including the burnout, the engine must only survive 900 revolutions under load.
* The redline is actually quite high at 9500 RPM.
*
THE BOTTOM LINE: Assuming all the equipment is paid off, the crew
worked for free, & for once, NOTHING BLOWS UP, each run costs an
estimated $1,000 per second.
The current Top Fuel dragster elapsed
time record is 4.441 seconds for the quarter-mile (10/05/03, Tony
Schumacher). The top speed record is 333.00 MPH (533 km/h) as measured
over the last 66′ of the run (09/28/03, Doug Kalitta).
(Jalopnik.com)
No comments:
Post a Comment